Product Categories
- Roll Forming Machine
- Cable Tray Duplex Roll Forming Machine
- Cold Roll Forming Machine
- Guardrail Roll Forming Machine
- Purlin Roll Forming Machine
- Roll Forming Machines For Automobile
- Roll Forming Machines For Door Framing
- Shelving And Racking Roll Forming Machine
- Step Tile Roll Forming Machines
- Stud and Track Roll Forming Machine
- Metal Roofing Machine
- Cutting & Slitting Lines
- Roll Forming Accessories
- Profile Collections
Today, we, Shaoxing Inbon Machinery Co., Ltd., will share the stud and track roll forming machine operating procedures with you. Hope it will be helpful when customers use our stud and track roll forming machine.
1. The operator must be familiar with the stud and track roll forming machine performance and operating procedures.
2. Must check the machine itself and around without any debris, obstacles before starting the machine. Check the instruments and buttons are all normal.
3. Trial operating for 10 minutes each time before you starting the machine. At that time, open the butter lubrication pump to make every point fully lubricated. Do not start with load.
4. During the operating process, add lubricants every 30 minutes to ensure the safe operation of the stud and track roll forming machine.
5. It is prohibited to stand at the top of the machine when it is running.
6. Stop to inspect immediately when there are abnormal vibration, hydraulic oil leaking and noise during operation.
7. Non-operating personnel are not allowed to get in the work area, and should keep more than 2 meters away from the rolling forming machine.
8. Stick to the post and don’t leave work without permission. If you have to leave, you should first stop the machine, and report to your leader.
9. The system pressure of the machine is 20Mp, and is strictly prohibited over-pressure working.
10. When finished the work, power off the stud and track roll forming machine and clean around.
More information about stud and track roll forming machine, please visit www.inbonrollforming.com.